RAMCHECK
SIMCHECK II
Tech Support
Introduction
Manuals
Software Downloads
FAQ
Calibration & Upgrades
SIMCHECK II Upgrade to RAMCHECK
Application
NotesDevelopment Logs
Service & RMA Policy
News Releases
Links
Site Map
Home
Contact us at
(281) 879-6226
sales@innoventions.com
RAMCHECK SUPPORT OF
CAS LATENCY 2 MODULES
INN-8668-APN4
--Revised 8-13-2001
This application note discusses the support of
CAS LATENCY 2 modules and their test and identification through the RAMCHECK
program.
If the high speed CAS Latency 2 is supported on the module tested (as required, for example, for the AMD Athlon processors), the SPD byte 23 will equal A0h to indicate a 10nS cycle time (at CL=2), and byte 24 will equal 60h to indicate a 6nS (or=65h to indicate 6.5nS) access time from clock. However, we have found that byte 24 may be left at 0 by some manufacturers.
| NOTE: The RAMCHECK memory tester identifies read SPD information by displaying "SPD=xx" both as part of the test summary following the Basic Test and as part of the test log. Measured information is displayed in the format "TEST=xx". Please refer to our application note INN-8558-APN12: SPD DATA STANDARDS for further information on each SPD byte location. |
The program identifies modules supporting the
Athlon processor at CAS LATENCY 2. It will report the message "SPD=100MHz
at CL2" in the last summary screen as well as in the Test Log.
The end of the BASIC TEST performs a 100MHz CAS LATENCY 2 test and reports a
message at the lower right corner of the display showing CL2=
if the module
under test passes this function.
Corresponding messages are also recorded in the Test Log.
For more information, please call us at (281) 879-6226 M-F 9:00-5:00 CST, or send your E-mail to support@innoventions.com, or fax your message to (281) 879-6415. Please remember to include your phone and e-mail.